A Fireside company - serving Boulder City, NV

Lennox Mini-Split Installation in Boulder City, NV

Ductless mini splitsDuctless mini splits
AC repairAC repair
Furnace & heatingFurnace & heating
Heat pumpsHeat pumps
CarrierCarrier
TraneTrane
GoodmanGoodman
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

We have financing partners for your new heating and cooling system*On approved credit; ask us about your options

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate

Lennox Mini-Split Installation: The Boulder City Owner’s Guide

Full Lennox mini-split installation typically runs $3,500 – $7,500 installed here, including the line set, pad or wall bracket, electrical, and startup. Most of that spread comes down to how many indoor heads you need and how long the refrigerant run has to be. We install Lennox mini-splits and we’re your local service company – we’re an independent provider, not affiliated with Lennox.

Call (844) 312-0133

Owners usually don’t start with “I want a mini-split.” They start with a spare room that never gets cool. A converted garage or an upstairs bedroom over the front of the house stays 8 degrees warmer than the rest of it through July, and running the central system harder doesn’t fix it. Others have a failing wall unit in a Boulder City casita or a workshop out back and want something that will still be working in fifteen years. Either way, the conversation is the same: a ductless Lennox system, sized right, installed once.

Key Takeaways

  • Installed Lennox mini-split systems in Boulder City run $3,500 – $7,500 depending on head count and line-set length.
  • Oversizing is the most common install mistake in our desert climate – it cools too fast to pull humidity and short-cycles the compressor.
  • Manufacturer warranties depend on a licensed, permitted install. Unpermitted work can void coverage on the equipment itself.
  • Every install we do is backed in writing by our 90-Day Done Right Promise.

Which Lennox Models This Applies To

Lennox sells ductless systems under its mini-split line, and the outdoor condenser and the indoor wall head are matched pairs – you can’t mix a condenser from one series with an indoor unit from another and expect the rated efficiency or the warranty to hold. When we quote your job, we’re matching the outdoor unit to each indoor head and to the refrigerant the system was built for. Newer Lennox mini-splits use R-410A or the newer R-32 refrigerant depending on the model year, and those two are never interchangeable; the wrong refrigerant in the wrong system is a hard no.

To identify what you have, find the data plate on the side of the outdoor condenser. It lists the model number, serial, and refrigerant type. The serial also encodes the manufacturing date, which tells us how old the system is and whether parts are still easy to source. If the plate has faded in the Boulder City sun – and they do – we can read the indoor head’s label instead, or measure the wall opening and the line-set diameter to confirm what will fit.

On the OEM-versus-aftermarket question for Lennox specifically: motors, control boards, and valves from Lennox are the safest match because they’re built to the exact spec the system was designed around. A quality aftermarket equivalent can work for some parts and costs less, but we’ll tell you plainly when the savings are real and when they’ll come back to bite you. We don’t carry parts on a truck, so we’re not steering you toward whatever happens to be sitting in the van. We source the right part for your model.

Explore

Styles & brands we work with

  • AC repair
  • Furnace & heating
  • Heat pumps
  • Ductless mini splits
  • Carrier
  • Trane
  • Goodman

Signs Your Lennox Mini-Split Installation Is Failing

When we say “installation,” your existing system already has one. These are the symptoms that tell us it’s failing – either the equipment or the original install work that’s now showing its age.

  • Ice forming on the indoor coil or the outdoor line. Usually low refrigerant from a slow leak, or a clogged filter restricting airflow. Both get worse the longer they run.
  • The wall head runs but the room never gets cool. Often an undersized unit or a refrigerant charge that was set wrong on day one. In Boulder City, an oversized unit that short-cycles also fails to pull humidity out of the air.
  • Water dripping from the indoor head. A clogged condensate drain or a drain line pitched the wrong way during the original install. This is one of the most common install defects we find.
  • Loud rattling or grinding from the outdoor condenser. A failing fan motor bearing or a loose mount, and in our heat, bearings wear faster than they do in cooler climates.
  • The system trips the breaker or won’t restart. A failing compressor, a bad capacitor, or a wiring issue. This one we don’t recommend you poke at yourself.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Here’s the range we quote for a full Lennox mini-split installation in Boulder City, with the same numbers we stand behind across the site:

  • Single-zone system: $3,500 – $4,800 installed.
  • Two-zone system: $4,800 – $6,200 installed.
  • Three-zone or larger system: $6,200 – $7,500 installed.

What pushes you toward the top of the range: a longer line set (refrigerant has to travel farther, so more copper and more charge), a wall-mount versus pad install, a 220-volt circuit that needs to be run new, and any drywall work to route lines through a finished wall. What’s included every time: the equipment, the line set, the electrical hookup, the drain, startup and charge, and a written fixed price before we start. The price quoted is the price paid – no surprise line items. And the whole job is covered by our 90-Day Done Right Promise: if it’s not right, we make it right, in writing, no arguing.

DIY or Call Us?

Some of this you can safely handle. Change the washable filter on each indoor head every few weeks – our dust and pollen load in Boulder City clogs them faster than you’d expect. Clear any debris from around the outdoor condenser. Check that the condensate drain isn’t visibly clogged. That’s it.

What you should not take on: refrigerant work. Mini-splits hold a pressurized charge, and handling it requires recovery equipment, gauges, and a license to do it legally. If you see ice on the line or suspect a leak, that’s a call-us situation, not a Saturday project. Same goes for electrical – a mini-split on a 220-volt circuit is not a job for a homeowner with a multimeter and a YouTube video. A wrong connection can damage the compressor, and a compressor is the most expensive part in the system.

If your current system is failing and you want to know whether it’s a repair or a replacement, call us at (844) 312-0133. We answer live, day or night, and the estimate is free.

FAQs

Need HVAC help nationwide? Licensed & insured · 60-minute response · free estimates
Call (844) 312-0133
Local Service Coverage

Request a Free Estimate in Boulder City

Tell us what you need - Fireside Heating & Air Co. Boulder City responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Us
Call Now - 24/7 Dispatch