AC repair
Furnace & heating
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateLennox Capacitor Replacement: The Boulder City Owner’s Guide
We replace a failed Lennox capacitor for Boulder City homeowners at a typical installed cost of $185 to $340, and most of those jobs are done the same day you call. We match the part to your unit’s model and microfarad rating, install it, test the compressor and fan motor under load, and back the work with our 90-Day Done Right Promise. The price quoted is the price paid. Most owners find us after the symptoms show up on a hot Boulder City afternoon: the outdoor fan hums but won’t spin, the compressor tries to start and clicks off, the house climbs past 85 while the thermostat still calls for cooling. A bulged or leaking capacitor is usually the reason, and it’s a part we can test and replace in a single visit.
Which Lennox Models This Applies To
Lennox has used run capacitors in nearly every residential condensing unit and air handler it has built, including the Merit Series (13ACX, 14ACX, XC13), the Elite Series (XC16, XC17), and the Signature Collection (XC21, XC25). Split systems across those lines share the same design: a dual-run capacitor feeding both the compressor and the outdoor fan motor, or separate start and run capacitors on older equipment. What changes between them is the microfarad (µF) rating and the voltage rating, and that’s where the wrong part gets installed. A capacitor rated 35/5 µF at 370V is not the same as a 45/5 µF at 440V, and putting the wrong one in shortens motor life or stops the unit cold.
To identify the right part, read the label on the existing capacitor itself (the µF, voltage, and tolerance are printed on the can), compare it to the wiring diagram inside the unit’s service panel, and confirm the model and serial on the rating plate. A good technician measures the old capacitor with a meter before replacing it, because a part that reads within 6% of its rated µF isn’t the problem. On the OEM-versus-aftermarket question for Lennox: a genuine Lennox-branded capacitor and a quality aftermarket equivalent from a known manufacturer (AmRad, Titan Pro, or a comparable US-made line) perform the same job when the specs match. We don’t push one over the other. What matters is correct rating and a part built to handle Boulder City’s summer heat, and we’ll tell you honestly which one we’d put in our own home.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Signs Your Lennox Capacitor Replacement Is Failing
A failing capacitor rarely dies quietly. Here is what Boulder City owners typically notice, and what’s happening underneath.
- The outdoor fan won’t start but the compressor hums. The fan side of a dual-run capacitor has lost capacitance, so the motor can’t get the phase shift it needs to start. The unit may run for a few minutes and then trip on high pressure because there’s no airflow across the coil.
- The compressor clicks and shuts off, then tries again. A weak run capacitor leaves the compressor drawing locked-rotor current, and the internal overload trips to protect it. Repeated start attempts are hard on the compressor, which is the expensive part you’re trying to save.
- The top of the capacitor is domed or leaking oily residue. Heat and age break down the dielectric inside. A bulged can or a wet-looking terminal is a failed part, not a maybe, and it needs to come out before it takes the motor with it.
- The unit runs but cools poorly and the fan spins slowly. Partial capacitance loss is common in our climate. The fan turns, but not at full speed, so the system runs long cycles and never quite keeps up on a 110-degree day.
- You hear a rhythmic clicking from the outdoor unit or a breaker trips. A shorted capacitor can pull the circuit breaker or cause repeated contactor chatter. Leave the disconnect off and call us rather than resetting the breaker again.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Boulder City, a Lennox capacitor replacement generally runs $185 to $340 installed. The low end covers a single-run capacitor on an accessible air handler; the high end covers a dual-run capacitor on a rooftop or hard-to-reach condensing unit, or a job that also needs the contactor checked and cleaned. That range includes the diagnostic, the part, labor, and a load test of the compressor and fan motor after the swap.
| Line item | Typical Boulder City range |
|---|---|
| Diagnostic and meter test | $75 to $110 |
| Capacitor (OEM or quality aftermarket) | $40 to $90 |
| Labor and post-install test | $70 to $140 |
| Total installed | $185 to $340 |
We quote the whole job upfront, so you know the number before we open the panel. The 90-Day Done Right Promise covers the work: if the replacement doesn’t hold, we make it right in writing, no arguing. And because the part often fails alongside a weak contactor or a dirty condenser coil, we’ll show you what we found rather than just handing you a bill.
DIY or Call Us?
There are a few things a homeowner can safely check before calling: that the outdoor disconnect is on, that the thermostat is calling for cool, and that the breaker hasn’t tripped. Beyond that, capacitor replacement is not a safe do-it-yourself job. The capacitor stores a charge even after the power is off, and touching the terminals can deliver a serious shock. The part also sits next to 240-volt wiring and a live contactor. We’d rather you leave the panel closed and let a trained technician handle it. Our technicians have up to 8 years of experience, they’re background-checked and uniformed, and they’ll test the old capacitor in front of you so you know the replacement was needed. Call (844) 312-0133 and we’ll get a live person on the line, day or night, and typically have you cooling again the same day.
FAQs
A run capacitor in our climate commonly lasts 5 to 10 years, and the summer heat here pushes more units toward the shorter end. Capacitors degrade faster when the condenser coil is dirty and the unit runs hot, so annual coil cleaning genuinely extends their life. If yours is original to a unit installed more than 8 years ago, it’s worth having it tested before peak summer.
No, a failed capacitor cannot be repaired and must be replaced. The dielectric inside is sealed and non-serviceable; once it bulges or loses capacitance, the fix is a new part. The good news is that it’s one of the least expensive repairs on a Lennox system, and it’s often the difference between a unit that runs and one that doesn’t.
A straightforward capacitor swap typically takes 30 to 45 minutes, including testing. If we find a related issue like a pitted contactor or a seized fan motor, we’ll explain it and quote any additional work before touching it. Most Boulder City jobs are finished in a single visit.
We match the part to your unit’s model plate and the µF and voltage printed on the existing capacitor, and we test the replacement before it goes in. We don’t claim to stock parts or carry them on a truck; we source the correct rating for your Lennox model and bring it to the job. Fireside Heating & Air Co. Boulder City is an independent service provider and is not affiliated with Lennox. We also service Carrier and Trane equipment, among the nine major brands we work on.
If your Lennox is clicking, humming, or just not keeping up on a hot Boulder City day, don’t wait for the compressor to pay the price. Call Fireside Heating & Air Co. at (844) 312-0133 for a free estimate. A live person answers every call, around the clock, every day of the year, and we’ll tell you straight what’s wrong and what it costs to fix it right.
Written by the team at Fireside Heating & Air Co. Boulder City, serving Boulder City and nearby areas.